Whilst Shelving System can be created, and modified into a huge array of different combinations.
We have also created 16 predefined standard sets, which make up some of the most popular models. The price of each set is calculated entirely from the included parts. So if you still want to add an extra shelf or build an extra bay. Then just add it.
NOVEMBER 11
​
​
PINCH IN BLACK
​
​
​
​
​
Initially introduced in untreated oak, the small clip is soon also available in black.
HOW TO ASSEMBLE
Film by Sho Matsuki / Directed by Iku Yamakawa
​
INSTALLING A BACK PLATE
​
To install a back plate, simply slide it down between the two legs until you meet the shelf surface. The back plate can be installed on either of the long sides.
​
INSTALLING A SAFETY CLIP
​
When all the shelves are in place, slide the safety hooks down the legs that meet the wall. Once in the place, mark where to drill, make a hole, and then install with the screw. Remember to use adequate wall plugs for your wall type.
​
If making a structure above 2.3m, then install safety clips not only at the top but also around the middle height of the full installation .
INSTALLING A SHELF
​
Place the first shelf on the floor, making sure that it is turned with the indicator dot facing down. Insert the first leg through the shelf and raise the shelf to the desired height. Set in place by pushing the wedge into the shelf from bellow. Repeat this for all 4 legs. You may find it easier to lay the system down when installing the first shelf. Install the following shelves sequentially.
​
CONNECTING THE LEGS
​
The two standard legs of 85 cm and 115 cm tall can be combined in any combination. Each leg is threaded on the inside. To join together, simply screw a threaded connector into one leg and screw on the next.
​
SHELVES ONLY WORK ONE WAY
​
The shelf plate looks similar on both sides. However, there is only one way up and one way down. On the underside of each shelf, you will find a small indicator dot located next to one of the leg holes. The side which contains the dot should always point downwards.
​
HOW TO LEVEL A SHELF
​
When installing shelves into the system, it can be difficult to see if the shelf is exactly levelled both vertically and horizontally. Use either a water level, a water level app or measuring stick to make sure you have it perfect.
​
2. HOW TO PUT TOGETHER:
​
BEGIN WITH THE LEGS
​
Insert an end cap into the one end of each leg that will touching the floor. Simply push in the end cap and give a tap with a hammer if needed.
​
1. BEFORE YOU START:
​
PLAN AHEAD
​
Before beginning to assemble your new system, be sure to plan ahead. Shelves and other elements have to be installed sequentially.
​